zd1211-base WIFI USB key with extension cable works ONLY during instal
Hello, I have a USB WIFI key plugged to a 3m USB cable extension. The key worked perfectly during the installation of Ubuntu 11.10 64bit but, after reboot it stops working. lsusb Code:
Bus 001 Device 006: ID 1435:0711 Wistron NeWeb UR055G 802.11bg This is the output I get: dmesg: Code:
[62973.868040] usb 1-6: new high speed USB device number 8 using ehci_hcd [62974.116042] usb 1-6: reset high speed USB device number 8 using ehci_hcd .. [62974.250024] ieee80211 phy3: Selected rate control algorithm 'minstrel_ht' [62974.251186] zd1211rw 1-6:1.0: phy3 [62974.356966] usb 1-6: USB control request for firmware upload failed. Error number -71 [62974.356979] usb 1-6: Could not upload firmware code uph. Error number -71 But the error code ranges from 71 to 110 to 29 lshw -C network: Code:
*-network DISABLED description: Wireless interface physical id: 1 bus info: usb<at>1:6 logical name: wlan0 serial: 00:10:a7:2e:ce:e9 capabilities: ethernet physical wireless configuration: broadcast=yes driver=zd1211rw driverversion=3.0.0-12-generic firmware=N/A link=no multicast=yes wireless=IEEE 802.11bg While this is the output I get if I use the key without the extension cable (and works perfectly): dmesg Code:
[62812.848038] usb 1-10: reset high speed USB device number 7 using ehci_hcd ... [62812.982194] ieee80211 phy2: Selected rate control algorithm 'minstrel_ht' [62812.983523] zd1211rw 1-10:1.0: phy2 [62813.127055] zd1211rw 1-10:1.0: firmware version 4605 [62813.167054] zd1211rw 1-10:1.0: zd1211 chip 1435:0711 v4330 high 00-10-a7 AL2230_RF pa0 g---- lshw -C network: Code:
*-network description: Wireless interface physical id: 1 bus info: usb<at>1:10 logical name: wlan0 serial: 00:10:a7:2e:ce:e9 capabilities: ethernet physical wireless configuration: broadcast=yes driver=zd1211rw driverversion=3.0.0-12-generic firmware=4605 ip=5.236.27.75 link=yes multicast=yes wireless=IEEE 802.11bg Can anyone help me, please? Thanks! |
No comments:
Post a Comment